|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-07-2016, 09:22 AM
|
#1 |
|
Registered User
Join Date: Feb 2001
Location: Wetumpka, Al, U.S.
Posts: 8,892
|
Any paid subscribers looking to do a 9 inch with spool soon
I am thinking about selling my axles spool a ND a Mark Williams Yoke. I think I am gonna go 40 spline.
I have moser gun drilled 35's with MW spline. I have the matching spool and a MW pinion yoke for a 1350 joint. I would take 500 plus the the ride. I can measure my housing but it is narrowerby than stock. I do still running trailing arms. 500 plus the ride.is have 5/8 studs but I have misplaced one.
__________________
Kevin Special Thanks to All who have helped on the TRUCK! My Pass Time Show http://s129.photobucket.com/albums/p...Chapter1-0.mp4 So Far my best Times are: Motor only: 6.44 1/8 @ 104.13 10.39 1/4 @ 125.83 Nitrous Times: 5.785 1/8 @ 118.65 with a 1.336 60ft 9.168 1/4 @ 142.58 with a 250 shot dead out of the hole! |
|
|
|
03-16-2016, 07:37 AM
|
#2 |
|
Registered User
Join Date: Feb 2001
Location: Wetumpka, Al, U.S.
Posts: 8,892
|
Re: Any paid subscribers looking to do a 9 inch with spool soon
Sold locally. Going 40 spline.
__________________
Kevin Special Thanks to All who have helped on the TRUCK! My Pass Time Show http://s129.photobucket.com/albums/p...Chapter1-0.mp4 So Far my best Times are: Motor only: 6.44 1/8 @ 104.13 10.39 1/4 @ 125.83 Nitrous Times: 5.785 1/8 @ 118.65 with a 1.336 60ft 9.168 1/4 @ 142.58 with a 250 shot dead out of the hole! |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
