|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-03-2016, 09:49 PM
|
#1 |
|
Registered User
 Join Date: May 2005
Location: Reading, Kansas
Posts: 628
|
spin on oil filter nipple
The engine in my 1966 1/2 ton is a 250. when motor was rebuilt the rebuilder removedand lost the oil filter nipple and now I need to find one, junk yard I know . The nipple is removed fromthe block via an allen wrench. Does anyone know what size that allen wrench is so that I can find one before going to the junk yard.? Thanks in advance
|
|
|
|
11-04-2016, 08:39 PM
|
#2 |
|
Registered User
Join Date: May 2005
Location: Reading, Kansas
Posts: 628
|
Re: spin on oil filter nipple
Anybody?
|
|
|
|
|
11-04-2016, 09:50 PM
|
#3 |
|
Registered User
Join Date: Sep 2012
Location: Dallas, GA
Posts: 1,497
|
Re: spin on oil filter nipple
Not sure off the top of my head.
I think I have a scrap block with one still in it, FWIW. Let me know if you're interested. Otherwise, I'll at least measure the hex for you if no one comes up with a number by then. |
|
|
|
|
11-04-2016, 09:55 PM
|
#4 |
|
Registered User
Join Date: May 2005
Location: Reading, Kansas
Posts: 628
|
Re: spin on oil filter nipple
Thanks
|
|
|
|
|
11-05-2016, 08:07 PM
|
#5 |
|
Registered User
Join Date: May 2005
Location: Reading, Kansas
Posts: 628
|
Re: spin on oil filter nipple
A 1/2 inch allen wrench is what is needed to remove oil filter nipple. Thanks to everyone who responded I found one (nipple) at the junk yard and is now installed in my 250 block. Cheers
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
