![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Dec 2016
Location: Salado, TX
Posts: 4
|
72 Hazard Light Problem Leads
I've been going thru a 72' (just got 3 months ago) getting it ready to get registered. My last item was getting the hazards working. The relay for the hazard flasher was missing, so i put a new one in there. Upon doing this and turning on the hazards, I lost all rear lights. Running lights, brake, etc. They are also now dead after pulling the flasher relay out. The front hazards did blink though when it was in. Previous to this, I had replaced the headlight control and the floor dimmer switch and everything was working.
Thus far I have looked at the back of the fuse panel for shorts and inspected the turn signal switch wiring. I don't see any blown fuses. Any ideas appreciated. |
![]() |
![]() |
![]() |
#2 | |
Senior Member
![]() Join Date: Feb 2002
Location: Tucson, AZ USA
Posts: 7,284
|
Re: 72 Hazard Light Problem Leads
Quote:
__________________
Every 25 years I like to rebuild that 292, whether it needs it or not. |
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Dec 2016
Location: Salado, TX
Posts: 4
|
Re: 72 Hazard Light Problem Leads
I'll check some bulbs tonight and begin tearing into the turn signal switch. Thanks '68OrangeSunshine
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|