![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jan 2015
Location: Boynton bch, FL
Posts: 187
|
Temperature gauge wire replacement
Somehow the wire from the block side popped off and plastic end melted to the headers. Is that something I can get locally? Easy to replace? My gauge went back and fourth and pegged at hot, will it be O.K. with new wire? Thanks
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Aug 2006
Location: Redmond, WA
Posts: 6,332
|
Re: Temperature gauge wire replacement
Gauge will be fine, it just touched ground which reads as "full hot". Won't hurt it at all.
The connector should be easy to find, it's a single-pole Packard connector, I would bet that most auto parts stores would carry it or something similar. Nothing special about the wire other than being green, you can extend/replace that as needed. So, no harm no foul and an easy fix.
__________________
1970 GMC Sierra Grande Custom Camper - Built, not Bought 1969 Pontiac 2+2 427/390 4-speed Coupe 1969 Pontiac 2+2 427/390 4-speed Convertible |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: May 2010
Location: Wisconsin & Arizona
Posts: 4,844
|
Re: Temperature gauge wire replacement
Try this. But it's not green like the original.
http://www.repairconnector.com/produ...Connector.html Last edited by FirstOwner69; 01-28-2017 at 06:40 PM. |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jan 2015
Location: Boynton bch, FL
Posts: 187
|
Re: Temperature gauge wire replacement
Thanks a lot guys
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|