Porterbuilt stuff

[bigmac73]

I am currently redoing my frame to include wire-wheeling and sanding the frame so i can OSPHO it all before i paint it,

I was looking at some replacement items from Porterbuilt Like the items below, My question is are these Items direct replacements or are they only for lowered trucks I want to keep the truck the stock height and stance

http://pbfab.com/63-72-trailing-arms...ece-driveshaft

http://pbfab.com/rear-frame-crossmember-63-72

http://pbfab.com/panhard-bar-crossmember

http://pbfab.com/67-72-front-tubular...rt-crossmember

http://pbfab.com/transmission-crossmember


I would like to use all the stuff above just want to make sure i can use regular springs and new trailling arms for a stock height

[70blackfish]

most of there stuff is for lowering your truck.....A1 quality too.

[bigmac73]

So what can I use and keep the truck a factory stance, I am just wanting to beef up the frame when I place the rear springs and trailing arms

[hotrodsinner]

Check out Early Classics Enterprises. ECE