|
08-13-2017, 01:24 AM
|
#1 |
|
Registered User
 
Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
Today's project
Well finally got to use my new bead roller and fab up some wheel tubs! I cold have used a hand to turn the crank while guiding the metal, wouldbhave been easier to make straight lines! Well at least now I dont have to worry about rocks and water slinging every where!
__________________
The Ghost 67 short wide full custom. 550 hp LSX, 4l80E, narrowed 9". Body dropped w/air ride! ........................ ___ .........________//__{\_____ ,,,,,,,/__(⊙)___//___/__(O)_/ @disciple2.rc 💪instagram💪 LED TAILS Last edited by Robznob11; 08-13-2017 at 01:40 AM. |
|
|
|
08-13-2017, 01:37 AM
|
#2 |
|
Registered User
Join Date: Dec 2012
Location: kearney nebraska
Posts: 613
|
Re: Today's project
Those are nice!!!! Sweet looking work right there
__________________
1972 GMC C20 Custom Camper 350/TH350 |
|
|
|
|
08-13-2017, 09:43 AM
|
#3 |
|
Senior Member
 Join Date: Jan 2015
Location: Kearneysville Wv
Posts: 3,955
|
Re: Today's project
Nice work here's a pic flip for you
|
|
|
|
|
08-15-2017, 12:52 PM
|
#4 |
|
Registered User
Join Date: Mar 2009
Location: WARRENSBURG,MISSOURI,64093
Posts: 1,518
|
Re: Today's project
What type of joint did you use to blank off the inside panel? "Pittsburg" type duct
Joint? Or did you buy the tubs pre-assembled? Ben 
__________________
"Persistence is the twin sister of Excellence.one is a matter of quality,the other, a matter of time" “Serious Black” my 1971 Short Bed Fleetside Sold to an outstanding man in Lees Summit,Mo. “Gone, but by no means,Forgotten” |
|
|
|
|
08-15-2017, 01:22 PM
|
#5 |
|
Registered User
Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
Re: Today's project
No i made them from scratch! I made the sides out of 24 gauge steel and welded on a 2" lip, i made the hoops from .32 aluminum and pop rivited them in place! No one made a 41"wide tub that was only 15 1/2" tall😞
__________________
The Ghost 67 short wide full custom. 550 hp LSX, 4l80E, narrowed 9". Body dropped w/air ride! ........................ ___ .........________//__{\_____ ,,,,,,,/__(⊙)___//___/__(O)_/ @disciple2.rc 💪instagram💪 LED TAILS |
|
|
|
|
08-17-2017, 07:41 PM
|
#6 |
|
Registered User
Join Date: Mar 2009
Location: USA
Posts: 255
|
Re: Today's project
Good job! It's always more fun making your own parts. I've always wanted to use one to put 3D flames in my hood, just never had the stones to cut up my hood. lol
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
