bedside toolbox molding - The 1947 - Present Chevrolet & GMC Truck Message Board Network

tdangle · 09-12-2017, 04:33 PM

OK
I'm stumped and don't want to ruin the molding getting it off. How is the lower molding held on the lid of the bedside tool box? I have a feeling it prys off but after 40+ years maybe not easily.

*randy500* · 09-12-2017, 05:16 PM

Clip fasteners in a blind hole, I have never had luck removing them but theoretically they do compress from opposite sides, I think those sides are top and bottom but could be wrong.

09-12-2017, 04:33 PM	#1
tdangle Registered User Join Date: Mar 2005 Location: Jurupa Valley, Ca Posts: 1,210	bedside toolbox molding OK I'm stumped and don't want to ruin the molding getting it off. How is the lower molding held on the lid of the bedside tool box? I have a feeling it prys off but after 40+ years maybe not easily. __________________ Terry 1970 Custom Camper/C20 , GM Crate 350/7004R, Dana 60, factory AC

09-12-2017, 05:16 PM	#2
randy500 Account Suspended Join Date: Jul 2016 Location: Tacoma, WA Posts: 6,873	Re: bedside toolbox molding Clip fasteners in a blind hole, I have never had luck removing them but theoretically they do compress from opposite sides, I think those sides are top and bottom but could be wrong.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.