|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-02-2018, 04:22 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
Swaybar for porterbuilt arms?????
Ok guys I looked at old threads and I see basically you have to run a pbfab bar or muscle bar. On guy says he thinks it's about 44" eye to eye. I just wonder if this hellwig bar would work. Its 41" eye to eye and 11" deep. Your thoughts????
__________________
The Ghost 67 short wide full custom. 550 hp LSX, 4l80E, narrowed 9". Body dropped w/air ride! ........................ ___ .........________//__{\_____ ,,,,,,,/__(⊙)___//___/__(O)_/ @disciple2.rc 💪instagram💪 LED TAILS |
|
|
|
05-03-2018, 10:32 AM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,064
|
Re: Swaybar for porterbuilt arms?????
I purchased a used PB spec'd bar from a board member for my dually because I didn't like the angle of the 'Posi-Links' of the Muscle Bar when installed & they seemed less than stout.
But after only a brief stint under the truck, each side of the installed PB spec'd bar shelled a bushing from binding. I wound up re-installing the Muscle Bar. I'm still researching options for replacing the Posi-Links w/something more robust.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
