|
06-29-2018, 08:37 AM
|
#1 |
|
Registered User
Join Date: Jun 2017
Location: Powder Springs, Ga
Posts: 50
|
Front end alignment
Putting my frame back together and I am needing advice and pictures of the upper control arm set-up and recommended shim starting point. Pulled shims out and put them in a bag before identifying. I am going to even out the shims front to back but can't remember where the concave washer goes. 1963 step side C10. Thanks
|
|
|
|
06-30-2018, 01:49 PM
|
#2 |
|
Moderator
  
Join Date: Aug 2011
Location: China Spring, TX
Posts: 7,280
|
Re: Front end alignment
Good thread on the subject of washers: http://67-72chevytrucks.com/vboard/s...d.php?t=589541
__________________
Master Chief, US Navy, Retired 1964 C10 Step-side Short Bed - In Progress 2009 2500HD Duramax LTZ 1948 GMC Panel 1956 Big Window Stepside 1953 5 Window Chevy Stepside 1932 Coupe New Seat Foam for Bench Seats? |
|
|
|
|
06-30-2018, 02:00 PM
|
#3 |
|
Registered User
Join Date: Jun 2017
Location: Powder Springs, Ga
Posts: 50
|
Re: Front end alignment
Thanks, I think I got the front end back together to where i will be in the ball park. Put the shim between the flat of the concave washer and the control arm shaft.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
