|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-02-2018, 09:12 PM
|
#1 |
|
Registered User
Join Date: Nov 2011
Location: Port St. Joe Fl.
Posts: 494
|
Distributor hold down clamp
Does anyone make a (hold down flange) that has some teeth to keep the dang distributor from turning after a couple weeks?
The HEI is too slippery for the chrome flange to keep it secure. If I had a Lathe I would knurl the dang thing...lol |
|
|
|
11-02-2018, 09:39 PM
|
#2 |
|
Registered User
Join Date: May 2012
Location: horseheads,ny rust belt
Posts: 2,794
|
Re: Distributor hold down clamp
take a hacksaw and cut a few groves in the bottom of the clamp at the 2 points .
__________________
77-k30lb BIG truck build . 87-k30lb budget beater build . 85-k30lb the plow machine build . 85-c10sb summer fun toy . ----------------------------- HOLLEY SNIPER efi = worst case of p.i.t.a i ever had . EDELBROCK pro flo 4 = best deal going so far . love my setup works great. |
|
|
|
|
11-02-2018, 09:49 PM
|
#3 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,591
|
Re: Distributor hold down clamp
Better yet use a big sharp cold chisel and rough it up.
Cut a cross hatch in it. |
|
|
|
11-02-2018, 10:04 PM
|
#4 |
|
Senior Member
 
Join Date: Dec 2009
Location: TN.
Posts: 8,064
|
Re: Distributor hold down clamp
Use a Triangle File or a Knife file.
Clamp it good and Hand make your own Knurls.
__________________
________________________________________________________________________________________ ____________________________________________ 84 Chevy K-20 63 Impala (my high school car) http://67-72chevytrucks.com/vboard/s...Crew Cab Build |
|
|
|
|
11-03-2018, 08:59 AM
|
#5 |
|
Registered User
Join Date: Nov 2011
Location: Port St. Joe Fl.
Posts: 494
|
Re: Distributor hold down clamp
Thanks for the ideas
|
|
|
|
|
11-03-2018, 10:55 AM
|
#6 |
|
Registered User
Join Date: Aug 2005
Location: Louisiana
Posts: 711
|
Re: Distributor hold down clamp
Nothing holds better than the original hold down clamp. try to find one from a local salvage yard or Ebay and your troubles will be over.
|
|
|
|
|
11-05-2018, 12:20 AM
|
#7 |
|
Registered User
Join Date: Jan 2007
Location: Garland,TX
Posts: 431
|
Re: Distributor hold down clamp
^^^^x2 The cheap chromed pot metal ones they sell at the auto parts stores will flatten out after removing and installing a few times. I found that out the hard way.
__________________
80 C10 SWB Step Side - 350 w/ vortec heads, TH350, 12-bolt 3.73 |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
