|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-10-2019, 11:01 AM
|
#1 |
|
Senior Member
 
Join Date: Jul 2018
Location: Bethany Connecticut
Posts: 370
|
Brake pushrod to short can I swap?
Working on a 1970 3/4 ton I ordered a brake booster from Napa part #54-71011
I am installing it now and the pushrod is 1-1/2” shorter so I can’t bolt it up to the pedal. Can I swap these out? Doesn’t seem to pull out? Don’t want to damage the new one if I have to bring it back. I looked up 1ton part number and it is the same? Any help would be appreciated Trip |
|
|
|
02-10-2019, 01:44 PM
|
#2 |
|
Senior Member
Join Date: Oct 2009
Location: Godley, TX
Posts: 17,975
|
Re: Brake pushrod to short can I swap?
Have you tried hooking up the vac source and starting the engine - not sure but that may move it toward where you need it.
|
|
|
|
|
02-10-2019, 03:38 PM
|
#3 |
|
Moderator
 
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,204
|
Re: Brake pushrod to short can I swap?
The rear brake booster shaft is not replaceable unless during a major overhaul...
I have seen this before... Check out https://www.napaonline.com/en/p/NBB5473709 Call the NAPA store, check their stock then take your old one to match the length..... Have fun... 
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox 
|
|
|
|
|
02-10-2019, 05:45 PM
|
#4 |
|
Senior Member
Join Date: Jul 2018
Location: Bethany Connecticut
Posts: 370
|
Re: Brake pushrod to short can I swap?
Yes that looks like my old one, I will order it tomorrow
Thanks for the link! Trip |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
