|
03-21-2019, 12:58 PM
|
#1 |
|
Registered User
Join Date: Mar 2019
Location: FAIRFIELD TEXAS
Posts: 7
|
1964 LS Swap wiring
I have a 1964 c10 i have swapped to a 6.0/4l80e. I need recommendations on where to get 12vdc in Run and Crank. I tried the posts at the fuse panel, but seemed like they were 12vdc at all times. Any help would be greatly appreciated.
|
|
|
|
03-21-2019, 01:56 PM
|
#2 |
|
Post Whore
  
Join Date: May 2015
Location: Alabama
Posts: 14,670
|
Re: 1964 LS Swap wiring
Welcome...
All you need is constant 12v and switch on 12v..the constant 12v can be pulled from hot side of your switch,battery,or any 12v power source...for the switch on 12v I used the power source going to the distributor
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
|
03-21-2019, 02:12 PM
|
#3 |
|
Registered User
Join Date: Mar 2019
Location: FAIRFIELD TEXAS
Posts: 7
|
Re: 1964 LS Swap wiring
Thank you.
So the pink wire that went to distributor for HEI or yellow for coil should give me a switched 12v source then? |
|
|
|
|
03-21-2019, 02:49 PM
|
#4 |
|
Post Whore
Join Date: May 2015
Location: Alabama
Posts: 14,670
|
Re: 1964 LS Swap wiring
Yep....
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
|
03-21-2019, 06:23 PM
|
#5 |
|
Registered User
Join Date: Mar 2019
Location: FAIRFIELD TEXAS
Posts: 7
|
Re: 1964 LS Swap wiring
So I only have a two post starter doesnt have the R terminal. Tried putting it on the same terminal with purple but that makes it try to crank in on position.
|
|
|
|
|
03-21-2019, 07:11 PM
|
#6 |
|
Registered User
Join Date: Mar 2019
Location: FAIRFIELD TEXAS
Posts: 7
|
Re: 1964 LS Swap wiring
Is it possible to use the Brn/wht from the accessory on ignition switch? I am not using the wiring to alternator since the ls harness has it built in.
|
|
|
|
|
03-21-2019, 07:14 PM
|
#7 |
|
Post Whore
Join Date: May 2015
Location: Alabama
Posts: 14,670
|
Re: 1964 LS Swap wiring
what are you trying to hook up?....the same wires that would crank over your old engine will crank over your LS....all those do is run the starter when the key is turned to crank...im not to familiar with 64 wiring
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
|
03-21-2019, 07:45 PM
|
#8 |
|
Registered User
Join Date: Mar 2019
Location: FAIRFIELD TEXAS
Posts: 7
|
Re: 1964 LS Swap wiring
The harness has a pink/blk that needs 12v at run and crank for the Fuel pump relay.
|
|
|
|
|
03-21-2019, 11:53 PM
|
#9 |
|
Post Whore
Join Date: May 2015
Location: Alabama
Posts: 14,670
|
Re: 1964 LS Swap wiring
are you using a homemade harness or store bought?
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
|
03-22-2019, 08:21 AM
|
#10 |
|
Registered User
Join Date: Mar 2019
Location: FAIRFIELD TEXAS
Posts: 7
|
Re: 1964 LS Swap wiring
The truck harness is OEM, the LS Swap harness is store bought from BP Automotive. I think i found terminals on fuse block that work though.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
