Front 4x4 bearing nut question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Erl · 12-01-2003, 05:37 PM

For a 3/4 4x4 Dana 44 does the front wheel bearing nut (inside the hub) have 4 or 6 slots?
Thanks

LeRoy · 12-01-2003, 08:13 PM

Are you talking about the nuts that you attach the hubwrench to. If so it's four

Duallie · 12-01-2003, 08:45 PM

Correct. The front hubnut has 4 tits and the rear hubnut on a 3/4 ton has six tits.

Erl · 12-02-2003, 11:48 AM

Thanks
I am going to buy a hub wrench and they come as a 4 slot or combo for 4 and 6. I did not know the back was a 6. Ordering the combo today.

12-01-2003, 05:37 PM	#1
Erl Registered User Join Date: Mar 2002 Location: Dallas, TX Posts: 555	Front 4x4 bearing nut question For a 3/4 4x4 Dana 44 does the front wheel bearing nut (inside the hub) have 4 or 6 slots? Thanks __________________ 1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX

12-01-2003, 08:13 PM	#2
LeRoy Registered truck nut Join Date: Dec 1999 Location: Mt. Vernon, Washington, USA Posts: 1,584	Are you talking about the nuts that you attach the hubwrench to. If so it's four __________________ MOUNT VERNON, WASH. STATE Need a part? Just PM me

12-01-2003, 08:45 PM	#3
Duallie Registered User Join Date: Feb 2001 Location: Nikiski, Alaska Posts: 477	Correct. The front hubnut has 4 tits and the rear hubnut on a 3/4 ton has six tits. __________________ Just as if I knew what I was doin'

12-02-2003, 11:48 AM	#4
Erl Registered User Join Date: Mar 2002 Location: Dallas, TX Posts: 555	Thanks I am going to buy a hub wrench and they come as a 4 slot or combo for 4 and 6. I did not know the back was a 6. Ordering the combo today. __________________ 1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.