I need a measurement. . . - The 1947 - Present Chevrolet & GMC Truck Message Board Network

clemsonteg · 09-17-2019, 10:04 AM

I am looking for a measurement between the top of the frame rail and the bottom of the wood floor directly above the axle. My frame and body are currently separated and I am trying to figure out how close the exhaust will be to the floor if I go over the axle. The airbags and bolt in c-notch are limiting my space.

**VictoriaHardware** · 09-17-2019, 12:15 PM

The Sub/Panel floor height is the same as pickups. In that area there is about 1/4" of clearance.

09-17-2019, 10:04 AM	#1
clemsonteg Registered User Join Date: Jul 2012 Location: Anderson,SC Posts: 953	I need a measurement. . . I am looking for a measurement between the top of the frame rail and the bottom of the wood floor directly above the axle. My frame and body are currently separated and I am trying to figure out how close the exhaust will be to the floor if I go over the axle. The airbags and bolt in c-notch are limiting my space.

09-17-2019, 12:15 PM	#2
VictoriaHardware Senior Member Join Date: Nov 2012 Location: Southeast Michigan Posts: 792	Re: I need a measurement. . . The Sub/Panel floor height is the same as pickups. In that area there is about 1/4" of clearance.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.