Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
07-31-2020, 10:16 PM | #1 |
Registered User
Join Date: Oct 2014
Location: Brandon, Manitoba, Canada
Posts: 979
|
Side trim hole location?
My 65 Fleetside never had side trim and I never drilled any prior to paint. I plan to 3m the trim on as I’ve seen on this forum. The trim strip was not painted on either and I plan to use a vinyl stripe between the trim. If someone could give me the vertical measurements from the crease down to the top and bottom holes I’ll run the vinyl trim width at that location. Thanks.
Last edited by bigmoe; 08-01-2020 at 02:47 PM. |
07-31-2020, 10:52 PM | #2 |
Registered User
Join Date: Oct 2014
Location: Brandon, Manitoba, Canada
Posts: 979
|
Re: Side trim hole location?
These are the holes I want to locate but not actually drill so I know where to put my stripe.
|
08-01-2020, 08:17 AM | #3 |
Moderator
Join Date: Aug 2011
Location: China Spring, TX
Posts: 7,280
|
Re: Side trim hole location?
Thread on measurements - http://67-72chevytrucks.com/vboard/s...d.php?t=517895
__________________
Master Chief, US Navy, Retired 1964 C10 Step-side Short Bed - In Progress 2009 2500HD Duramax LTZ 1948 GMC Panel 1956 Big Window Stepside 1953 5 Window Chevy Stepside 1932 Coupe New Seat Foam for Bench Seats? |
08-01-2020, 09:03 AM | #4 |
Registered User
Join Date: Oct 2014
Location: Brandon, Manitoba, Canada
Posts: 979
|
Re: Side trim hole location?
Is it on this one? I'm sorry I don't know if it's my monitor but I can't read the numbers. Do they use the crease to measure from?
|
08-01-2020, 09:37 AM | #5 |
Registered User
Join Date: Oct 2014
Location: Brandon, Manitoba, Canada
Posts: 979
|
Re: Side trim hole location?
another
|
08-02-2020, 02:55 PM | #6 |
Registered User
Join Date: Oct 2014
Location: Brandon, Manitoba, Canada
Posts: 979
|
Re: Side trim hole location?
I got some info from a guy who measured his holes for me. He says the top row of holes is 1 7/8" down from the crease to center of holes. The second row of smaller holes is 2 1/2" down from that, center to center. So the stripe is 2 1/2" wide.
|
08-03-2020, 05:14 PM | #7 |
Active Member
Join Date: Aug 2015
Location: Greenville, SC
Posts: 129
|
Re: Side trim hole location?
I plan to do the same exact trim addition with the 3M and vinyl stripe to my '65 one day, so this thread will come in handy one day when I need the measurements.
Thanks, and Good Luck! |
08-03-2020, 08:47 PM | #8 |
Registered User
Join Date: Oct 2014
Location: Brandon, Manitoba, Canada
Posts: 979
|
Re: Side trim hole location?
It will take some measuring and figuring, especially where the front of the stripe curves up but I have the measurements I need to get started.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|