![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: May 2017
Location: River Falls, WI
Posts: 4
|
1978 250 Piston Assembly Advise
Hi all. I was assembling my pistons today and may have run into an issue I need advise on. I heated up my existing rod and installed the pin in the piston and it ended up a little bit off center. Will this cause an issue? If so, how can I fix it without damaging the new parts? Thanks in advance for any help.
|
![]() |
![]() |
![]() |
#2 |
Moderator
![]() Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,191
|
Re: 1978 250 Piston Assembly Advise
I will assume you dont have access to a press and spacer plates...
Its a simple fix... I would take the piston / rod assembly to an engine shop and have them press the pin deeper into the rod...from the pics, it only needs about 1/8" to 3/16" to center the rod on the pin in the opening. I know a lot of shops never heat the rods, they just press the pin directly into the rod....WARNING....dont try that at home unless you are very experienced.... The rod should be centered in the opening in the piston and each end of the pin should be roughly flush with the pin bore in the piston skirt.
__________________
Family and country before all others... 2006 Chevy Silverado (Daily Driver) 2012 Chevy Equinox ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: May 2017
Location: River Falls, WI
Posts: 4
|
Re: 1978 250 Piston Assembly Advise
Thank you for your advise. I had it pressed to spec.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|