|
12-15-2003, 11:41 PM
|
#1 |
|
Registered User
Join Date: Nov 2002
Location: Eureka Springs AR
Posts: 494
|
cab mounts
I'm putting new cab mounts on my project. Since the cab wasn't on the frame when I got it and the old mounts are gone I don't know what order they go and which washer goes where. I have new mounts and hardware. any help thanks.
 
__________________
Buy Sale or Trade 71 3/4 4x4 72 1/2 ton cheyenne 4x4 |
|
|
|
12-16-2003, 02:04 AM
|
#2 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
Big washer, stock is vulcanized to the rubber, big rubber, frame little rubber, little washer, nut. That is for the rear cab. The front cab uses a big rubber that is smaller than the rear big mount but bigger than the rear small mount. Also the bottom mounts are a cone shaped mount while the body to frame mounts are hourglass shaped. Clear as mud??
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
|
|
12-16-2003, 07:18 AM
|
#3 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
I have pics of each in the link in my signature.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
