|
02-22-2021, 11:22 AM
|
#1 |
|
Registered User
Join Date: Oct 2015
Location: Williamston, Mi
Posts: 884
|
Cast Headers
I have a new set of Langston cast iron headers I'm going to install on my 292. I'm thinking I would like to have them powder coated. If I do this will this last or will it slowly burn off? I'm sure a few have probably done this so I'n just looking for any advise. Also does anyone have a ball park figure on approximately how much this should cost to have done? Never had anything powder coated so this is a new experience.
|
|
|
|
02-22-2021, 12:00 PM
|
#2 |
|
Registered User
Join Date: Jan 2007
Location: Puyallup, WA
Posts: 1,662
|
Re: Cast Headers
If you're going to have them coated, get them ceramic coated.
__________________
72 C10 lwb fleetside -stock 350/350 combo |
|
|
|
|
02-22-2021, 03:14 PM
|
#3 | |
|
Registered User
Join Date: Oct 2015
Location: Williamston, Mi
Posts: 884
|
Re: Cast Headers
Quote:
|
|
|
|
|
|
02-22-2021, 06:08 PM
|
#4 | |
|
Registered User
 
Join Date: Dec 2017
Location: Albuquerque NM
Posts: 32
|
Re: Cast Headers
Quote:
Regular powdercoat will burn off exhaust manifolds or headers. A good ceramic powder coat (Cerakote, Jet Hot) will not. I had a local company Cerakote my headers, downpipe and turbo for my street/strip car. Has held tough and keeps the underhood temps down. |
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
