disc conversion question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

taser · 01-03-2004, 02:23 AM

allright, i bought a new front end with 307 gears. the drum one on there right now is 3.73, so could i just take of the disc components and put them on my current front end...any help appreciated - todd

Mike C · 01-03-2004, 10:58 AM

Do you have an open or closed knuckle front? Would help if we knew what year your truck was.

taser · 01-03-2004, 02:55 PM

i have a 71 blazer, that oddly enough has drums up front. open knuckles though. so are the ones i picked up out of a 73.

01-03-2004, 02:23 AM	#1
taser Registered User Join Date: Sep 2003 Location: albuqueque Posts: 105	disc conversion question allright, i bought a new front end with 307 gears. the drum one on there right now is 3.73, so could i just take of the disc components and put them on my current front end...any help appreciated - todd

01-03-2004, 10:58 AM	#2
Mike C Registered User Join Date: Dec 1999 Location: Austin, TX, USA Posts: 7,727	Do you have an open or closed knuckle front? Would help if we knew what year your truck was. __________________ 44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-03-2004, 02:55 PM	#3
taser Registered User Join Date: Sep 2003 Location: albuqueque Posts: 105	i have a 71 blazer, that oddly enough has drums up front. open knuckles though. so are the ones i picked up out of a 73.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.