Rocker & Floor Fitment - The 1947 - Present Chevrolet & GMC Truck Message Board Network

booth · 03-20-2005, 09:45 AM

I don't know,

I used the cab mount as the set point for the patch. Everything lined up great next to the hump. Next to the rocker and up in to the kick panel is where I was havin my troubles. A little snip here and a cut there... bingo, a pain in the butt patch is complete. I have a high hump cab. I think these patches were designed for low hump cabs possibly? I did have to do some reshaping around the hump,to fit the flange for the bolts a little better.

Off to the shop to finish her up.
Later,
Paul

03-20-2005, 09:45 AM	#12
booth Active Member Join Date: Feb 2003 Location: Lonsdale, MN Posts: 109	I don't know, I used the cab mount as the set point for the patch. Everything lined up great next to the hump. Next to the rocker and up in to the kick panel is where I was havin my troubles. A little snip here and a cut there... bingo, a pain in the butt patch is complete. I have a high hump cab. I think these patches were designed for low hump cabs possibly? I did have to do some reshaping around the hump,to fit the flange for the bolts a little better. Off to the shop to finish her up. Later, Paul __________________ '67 Chevy LWB (Running) '67 Chevy LWB (Not Running) '70 Chevy LWB (In Pieces) '72 Chevy LWB (In Pieces)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.