Oil pressure gauge - The 1947 - Present Chevrolet & GMC Truck Message Board Network

R@nger · 04-13-2005, 10:52 PM

small block 350 V8 is what I have.

I got the idea of a braided line from a couple places online...it seemed like a good idea because it would be flexible.

When I got the truck there was a thin metal tube going through my firewall...thing was it was cut on either side of the firewall. I'm thinking someone cut it and got to lazy to just pull the little piece of tube out.

Shifty is there any way I could make mine electrontic, or would that require me to get a new oil pressure gauge. At the moment the stock one is in there. Seems like a whole lot easier to just run a wire to the gauge as apposed to running a whole pipe up to it.

04-13-2005, 10:52 PM	#1
R@nger Psalm 23 Join Date: Apr 2005 Location: Utah Posts: 360	small block 350 V8 is what I have. I got the idea of a braided line from a couple places online...it seemed like a good idea because it would be flexible. When I got the truck there was a thin metal tube going through my firewall...thing was it was cut on either side of the firewall. I'm thinking someone cut it and got to lazy to just pull the little piece of tube out. Shifty is there any way I could make mine electrontic, or would that require me to get a new oil pressure gauge. At the moment the stock one is in there. Seems like a whole lot easier to just run a wire to the gauge as apposed to running a whole pipe up to it. __________________ 71 GMC Fleetside C15(cab), 3/4 ton, 350, Holley Street Avenger 570cfm carb, TH350 trans, Leaf-springs, 2WD. "Peter are you sleeping on the job? No I have a bug in my eye and I'm trying to suffocate him." - Family Guy Last edited by R@nger; 04-13-2005 at 11:00 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.