|
04-09-2006, 04:03 PM
|
#1 |
|
Registered User
Join Date: Mar 2005
Location: minnesota
Posts: 78
|
Panel thickness Q
Got a quick question about the 69-72 blazer's....I've got a '71 K5, and need to repair/fabricate a few parts on the body (Okay, a lot of parts on the body, but anyway...)
I'm looking at repair panels, a few brag about being 19 Ga steel or somewhere around there - what I'm wondering is, what is the thickness of the stock panels? I was thinking about buying some steel sheet off of ebay or a local surplus shop, to patch the flat areas under the rear bed floor and behind the front seats. So how thick are the stock panels? Also, does anyone have a link or chart of what gauge corresponds to a metric or fractional measurement of thickness? Thanks. |
|
|
|
04-09-2006, 07:51 PM
|
#2 |
|
Registered User
Join Date: Mar 2004
Location: Sacramento, CA
Posts: 1,083
|
Re: Panel thickness Q
I believe 19 guage is correct!
__________________
'71  Jimmy, 350, SM465, NP205, 2in Tuff Country lift, 33s on rallies, TBI, softtop and hardtop"If life was fair you'd be able to afford one of each and a garage large enough to house them all." |
|
|
|
|
04-10-2006, 10:39 AM
|
#3 |
|
Senior Member
 
Join Date: Jun 2002
Location: Murray, Kentucky
Posts: 3,477
|
Re: Panel thickness Q
Here's a link for gauge to inch comparison.
http://www.unc.edu/~rowlett/units/sc...heetmetal.html Roger
__________________
Roger '68 Short step - https://67-72chevytrucks.com/vboard/...d.php?t=849675 '69 ('70?) 2wd Blazer '70 GMC Jimmy 2wd '73 Firebird - https://67-72chevytrucks.com/vboard/...d.php?t=853203 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
