Is this the right tool for the job? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

MStokes · 10-30-2002, 03:34 PM

When I did mine a couple of weeks ago, it was the first time I had ever taken a manual locking hub apart. It is pretty straight forward especially once you get all the parts out so that you can see them. I was following directions in a Haynes manual and it was very accurate as to the parts and steps that I had to follow. Make sure you closely follow the directions for putting it back together. There is a set proceedure for torque on the locknut when you reinstall.

Good Luck.

10-30-2002, 03:34 PM	#12
MStokes Registered User Join Date: Aug 2002 Location: Meridian, Idaho Posts: 164	When I did mine a couple of weeks ago, it was the first time I had ever taken a manual locking hub apart. It is pretty straight forward especially once you get all the parts out so that you can see them. I was following directions in a Haynes manual and it was very accurate as to the parts and steps that I had to follow. Make sure you closely follow the directions for putting it back together. There is a set proceedure for torque on the locknut when you reinstall. Good Luck. __________________ 1972 C-10 LWB, 400/350, 2WD 1972 C-20 Custom Camper, 350/350, 4WD (Converted)



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.