|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-20-2008, 10:49 AM
|
#1 |
|
Registered User
Join Date: May 2006
Location: Seaford De
Posts: 29
|
changing a truck from a 3 speed to an Automatic
do i need a different crossmember for the tanny?
or can i use the same one that i have for the # speed... one mount in that back? |
|
|
|
10-20-2008, 10:55 AM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: changing a truck from a 3 speed to an Automatic
you need to remove the crossmember that is under the engiine/bellhousing and you'll also need an automatic tranny crossmember to go under the tailshaft of the tranny
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
10-20-2008, 12:04 PM
|
#3 |
|
Registered User
Join Date: Jul 2007
Location: Covina Calif
Posts: 172
|
Re: changing a truck from a 3 speed to an Automatic
You need a different trans mount and a different starter the starter for the manual trans mounts to the bellhousing. The one you need for the automatic mounts to the engine block with a stright across bolt pattern or a staggered one. The auto crossmember has 2 small peaces on the ends that has to fit between the frame. I just drilled out the rivets an used only the bottem part of the crossmember my trans guy said it is strong enough.
__________________
"Your trucks fast! You must have been going 120 when I passed you." "Owning A 10 Sec Import Is Like Coming Out Of The Closet, In The End Ur Still Gay" If for some reason i loose to a import...At least i can go home knowing the vehicle i drive drops girls panties... |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
