|
12-18-2008, 03:43 PM
|
#1 |
|
Registered User
Join Date: Nov 2007
Location: Southern, California
Posts: 66
|
Two questions
When I do the 2" lowering blocks in the rear of my 69 C10 long bed do I need to change the pinion angle?
Also can I get a picture of the stock hi/low horns in the stock location. I stripped the engine compartment bare, and forgot how they mount. |
|
|
|
12-18-2008, 05:19 PM
|
#2 |
|
Dave's not here, man
Join Date: Jun 2004
Location: Winder, Georgia
Posts: 2,000
|
Re: Two questions
If you have stock springs I can't see a 2" block throwing off the pinion angle that much. I have 5" inch springs and it changed my pinion angle, but I don't think you'll have any problems. No clue on the other question, though. I'm sure someone else will chime in on it.
__________________
- 2014 VW Jetta - 2015 VW Jetta - 1966 Ford F-250 |
|
|
|
|
12-18-2008, 08:30 PM
|
#3 |
|
The Older Generation
   
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,395
|
Re: Two questions
-
This thread shows a pic of the horns. One is down and to the left so it's kind of hard to see... http://67-72chevytrucks.com/vboard/s...highlight=horn LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - Last edited by LockDoc; 12-18-2008 at 08:30 PM. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
