Re: Are tank selector valves known to block fuel flow?
Quote:
Originally Posted by 87 STEPPER
Before you buy another pump do this...........
Disconnect the pressure and return lines for the good tank at the selector vlv and place the pressure guage into them and run the pump and check the pressure if its anything above the 7.5 the selector vlv is stuck 1/2 way or has an obstruction.
|
I was looking at doing this, I had the selector shield cover off and looking at this. Problem is, there is barely any rubber hose to work with and not sure how I would connect those into the gauge adapter since the adapter has threaded female ends. Very little room unfortunately to tap in a gauge there. http://www.jegs.com/i/JEGS/555/15271/10002/-1 That may be exactly what I need but it still will be a very tight fit. I believe the truck uses 3/8'' Fuel hose at the selector valve?
__________________
87 Chevy 2wd SWB: 305/700r4 Dual Exhaust, K&N Filter, Injector Pod Spacer, TBI Spacer, Belltech Front Sway Bar, Corvette Servo, Western Chassis 4/6 and c-notch
Last edited by chevymotocross; 03-11-2009 at 07:44 PM.
|