|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-10-2009, 04:33 PM
|
#1 |
|
Registered User
Join Date: Oct 2009
Location: Bell, Ca.
Posts: 26
|
Question for red rocker
I was reading on-line about the build on truckins site. It said you relocated the cross member 2 in to gain clearance for the control arms. My question is, did you relocate the stock cross member or did you fabricate one?
__________________
1985 GMC S/S. Under complete reconstruction. |
|
|
|
12-10-2009, 05:02 PM
|
#2 |
|
The Cheesiest
 
Join Date: Aug 2008
Location: SHALLOWATER, TX.
Posts: 986
|
Re: Question for red rocker
Sectioned the factory crossmember
|
|
|
|
|
12-10-2009, 07:07 PM
|
#3 |
|
Registered User
Join Date: Oct 2009
Location: Bell, Ca.
Posts: 26
|
Re: Question for red rocker
Thank you sir. I haven't taken the front end apprt yet, are there any considerations I should take as far as geometry or is it pretty much "cut and paste"?
__________________
1985 GMC S/S. Under complete reconstruction. |
|
|
|
|
12-10-2009, 07:14 PM
|
#4 |
|
The Cheesiest
Join Date: Aug 2008
Location: SHALLOWATER, TX.
Posts: 986
|
Re: Question for red rocker
Its not cut and paste, but has been done many, many times!!
|
|
|
|
|
12-10-2009, 09:46 PM
|
#5 |
|
Registered User
Join Date: Feb 2009
Location: washington the state
Posts: 730
|
Re: Question for red rocker
I like that "cut and past"
I say gohead and cut and past but dont paint because it may become cut and replace  the cross member cut down job is a pretty easy job after you've done one or seen one done
__________________
my sports car rolls on six wheels only because I'm to fat to get in and out of new corvette http://hubgarage.s3.amazonaws.com/ph...ped_detail.JPG Last edited by pig rig; 12-10-2009 at 09:49 PM. |
|
|
|
|
12-10-2009, 11:00 PM
|
#6 |
|
Account Suspended
Join Date: Jul 2008
Location: Where I come from, it's cornbread and chicken...
Posts: 3,122
|
Re: Question for red rocker
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
