wheel bearing failure need help!!!!

[bucannon]

Originally Posted by primetime

did you actually pull out the cotter pin? or did the ends of it break off leaving the insides of the cotter pin in place? because that might be what is preventing the washer from sliding out.

the cotter pin pulled out fine in one piece, the nut came off easily, but the washer behind it is fugged up and twisted stuck on the spindle threads...

But i have already ordered new 4" lift spindles so im not concerned about trying to save the old stock spindles.






i have searched ebay and craigslist and have had no luck finding the 3/4 ton lower control arms but it shouldnt be much longer before some show up.



does anyone have pictures of a 73-87 2wd with lift spindles other than Dino's beast of a truck?