|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-09-2010, 04:25 PM
|
#1 |
|
Registered User
Join Date: Nov 2009
Location: Mesa, AZ
Posts: 226
|
Flipping the carrier bearing on lowered truck
For those of you who have done this, I have a couple questions.
A stock type carrier bearing has no issue being flipped, and the weight of the DS pushing on the mount vs. pulling on it, does it? Does the stock DS end up being too long after this is done? I was under the truck the other day and the whole process looked easy enough. Drill out/chisel 4 riviets, flip the mount over, and move it upward, then drill 4 holes. What bolt size is adequate....I was thinking something in the 7/16" range? |
|
|
|
07-13-2010, 12:26 PM
|
#2 |
|
Registered User
Join Date: Nov 2009
Location: Mesa, AZ
Posts: 226
|
Re: Flipping the carrier bearing on lowered truck
bump
|
|
|
|
|
09-30-2010, 05:13 PM
|
#4 |
|
Registered User
Join Date: Feb 2010
Location: so cal
Posts: 436
|
Re: Flipping the carrier bearing on lowered truck
make that 3.
__________________
big old burb in primer.lot of work to do. |
|
|
|
|
09-30-2010, 05:13 PM
|
#5 |
|
VA72C10
 
Join Date: Mar 2008
Location: Midlothian, VA
Posts: 25,269
|
Re: Flipping the carrier bearing on lowered truck
I did it on my LWB frame but never actually drove on it. I know boardmember iveldesigns did it on his and has put a lot of miles on it with no issues. No change to driveshaft necessary
__________________
Looking for a 67-72 swb or blazer project in or around VA. 
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
