|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
02-06-2011, 06:48 AM
|
#14 |
|
Account Suspended
Join Date: Mar 2007
Location: san bernardino ca. everywhere
Posts: 3,938
|
Re: Torque values for trailing arms and U-bolts needed
i just did mine tonight but did not use a torque wrench or any torque setting. i just tightened them down as tight as i could get them with an 18" long 1/2" drive breaker bar. hope that will be good enough, will recheck them later after i get a few miles put back on her.
Last edited by project 67 sub; 02-06-2011 at 06:48 AM. |
|
|
| Bookmarks |
|
|
Threaded Mode