|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-20-2011, 09:44 PM
|
#1 |
|
Registered User
Join Date: Nov 2010
Location: Las Vegas, Nevada
Posts: 160
|
Question about SM465 output shafts.
Weather a 4x4 SM465 is bolted to a 205 or a 208, is the actual output shaft the same length and 10- spline? I know the adapters are different, I just need to know if I can buy a 465 from a 208 and use it with my 205?
__________________
T.Y.N Custom Works..... Because "Stock" Sucks! 1971 K 10 GMC Long Bed 1977 Formula T/A Frame off Resto-Mod  1995 FXDL Harley Low Rider 1985 C10 ShortWide 91 Burb front. |
|
|
|
03-21-2011, 12:10 AM
|
#2 |
|
Getcha Pull
Join Date: Nov 2010
Location: MD
Posts: 691
|
Re: Question about SM465 output shafts.
As far as I know all NP208 465's are 32-spline round pattern. So if you have a figure-8 style pattern case that is 10-spline the easiest option would be to find the matching tranny.
Or do what I am doing. I found a 32-spline 465 with a NP208. I'm going to use this combination until I can find a 32-spline NP205. Edit, A SM420 should also bolt right up to your 10-spline NP205 IIRC.
__________________
'81 K10 454/SM465 '86 S10 Blazer '95 H-D Softail '96 Integra Last edited by Altec; 03-21-2011 at 12:11 AM. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
