Ididit but not yet. Need steering column help.

[Autoblueprint]

Originally Posted by derotoreut

Yes the bump or nub that I'm referring to is the raised area that gets indexed to the slot in the OEM column. The Ididit column does not have this feature. I'm not sure how you index the Ididit column manually. I did not see anything related to this in the instructions. Also on my column the wires must come out facing up. This is dictated by the turn signal location and tilt lever. It appears the column can be located in any position (slide up or down) as long as the turn signal is in proper alignment. As recommended by Richard H., I located the column as close as possible to the dash. I hope this is right.

I think the difference in our columns is that mine is without column shift ( I'm using a Hurst Pro-Matic 2 truck floor shift )...but it seems like you are doing everything correctly. The Ididit column can be be located in any position ( up / down ) just make sure it is not down too far that you would have difficulty removing / installing the instrument cluster. Set the column to where you want it and if there is no interference with the cluster you are good to go.