|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-09-2011, 12:03 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2010
Location: charlotte nc
Posts: 302
|
Need measurements plz help
I just installed the DJM flip kit in my truck im looking for measurements to make sure my axle is in generally the same position...
the measurements im looking for is from center of the front wheel to center of the rear wheel and from the outside of the rear frame rail to the inside of the drum in the rear... Any help would be amazing thanks guys... its going in for an alignment thursday at work if we are not busy at toyota but im just trying to get a general idea of how close or how off my rear end is |
|
|
|
07-09-2011, 12:27 PM
|
#2 |
|
Registered User
Join Date: Jun 2011
Location: Baytown TX
Posts: 2,219
|
Re: Need measurements plz help
What makes you think your rear end is possibly not in the right position?
Posted via Mobile Device
__________________
John 82 Chevy Silverado 350ci/TH350 
|
|
|
|
|
07-09-2011, 12:32 PM
|
#3 |
|
Registered User
Join Date: Feb 2010
Location: charlotte nc
Posts: 302
|
Re: Need measurements plz help
The fact that my axle moved a lot side to side durning installation due to one of my jacks breaking
Posted via Mobile Device |
|
|
|
|
07-09-2011, 12:40 PM
|
#4 |
|
Registered User
Join Date: Jun 2011
Location: Baytown TX
Posts: 2,219
|
Re: Need measurements plz help
As long as you lined up the flip brackets with the center bolt in the leaf springs and have the hole in the flip bracket forward it should all be lined up. If your still concerned I can take some measurements in a couple of hours.
Posted via Mobile Device
__________________
John 82 Chevy Silverado 350ci/TH350
|
|
|
|
|
07-09-2011, 12:49 PM
|
#5 |
|
Registered User
Join Date: Feb 2010
Location: charlotte nc
Posts: 302
|
Re: Need measurements plz help
ok sweet sounds good... thank you very much
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
