Vortec Intake manifold decision on '67 327

[Spassmacher]

I'm rebuilding my first 327 for my 67 c20. I've decided to go vortec on the heads, but I can't decide which intake manifold to go with. I've decided on these heads, and my carb is an Edelbrock 650cfm 4 brl. It may not make much of a difference, but I wasn't sure whether to go with the Summit Racing Stage 3 manifold or the Edelbrock 2116. There are also a ton of header options, and I just don't even know where to start. I'm not concerned with the finish on anything, just performance. Thanks for any suggestions guys. I've finally got a little money together, and a great place to put it all together, and I can't wait to get started.

Also wanted to add that as far as the headers go, this truck is supposed to be a little rough around the edges and loud as $%^!. It's flat black, body's a tiny bit dinged up, and I want headers and exhaust that are going to improve performance and make noise. Ya know... the basics. Thanks guys!

[Pop's C-10]

Get tha edlebrock & 1 5/8's headers 2 1/2 pipes & you good..

[VWBeamer]

The Elderbrock is worth the extra, IIRC the summit is made off shore. Nothing against Summit, but you the Elderbrock is going to fit correctly and be top quality.

[Spassmacher]

Thanks, I appreciate that guys. I was leaning towards Edelbrock because I already have the nice Edelbrock carb. I'm a union electrician and so I try to buy American made when I can. That makes the decision even easier.
Posted via Mobile Device