Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
11-15-2011, 03:45 PM | #1 |
Registered User
Join Date: Jul 2011
Location: Vancouver Island/Calgary
Posts: 22
|
Re: Should I diy bedliner the whole box/inside of fenders?
I plan to keep the truck for a while and perhaps some good photos are in order just to show the rust isn't to bad if I do plan to sell. Bedliner the panel up against the cab too? Anyone done this?
Good point on the bolts, I will try to keeps the coats thin on areas where fastaners are needed. Posted via Mobile Device
__________________
71 GMC C2500 350 all original, 80k miles, work truck 71 Chev C20 350 currently needs rear axle, play truck Both baby blue from the factory |
Bookmarks |
|
|