TX WTB 64-66 4x4 long frame

[Erl]

Looking for a long 4x4 frame in good shape with no running gear.

[62 short step]

Email this guy Rich.

rjsisneros@ria.net

He possibly might have one. Tell Jeremy gave you his email.

[Erl]

Thanks, I will contact him

Erl

[BLK65K10]

If RJ cant help you I have a couple. Shoot me and email . gmc1966@frontier.com

Old School Parts(60-66)
Lyle

[trevrolet65]

Erl, you still looking for a V6, pm me. Will a 2wheel frame work with mods?

[Erl]

Yes, I am still looking for GMC V6 engines. I am mainly interested in paying for the 351, 401 and 478 magnum size. I will take a free 305 if it is not too far away. A 2WD frame will work with some fabrication. But it is much easier to have a 4x4 frame.
Erl

[trevrolet65]

My buddy has a 351 out of a camper conversion,67 he wants gone cheap/make offer deal in Alvarado. I'll have a 2wheel frame without the c-member cheap/make offer. I'll take the cab,clip and bed off I'm useing. The motor is a 351V6 married trans with low miles, I think 78,000 on odometer? pics.

[BLK65K10]

If you want something closr to home you might look for a one ton. The onetons have the same basic frame as the 4x4 with the exception aof a couple of crossmembers and front spring mounts. You do have to fine the short wheel base oneton though. 127". A one ton frame is a much easier swap to 4x4 than a 1/2 or 3/4 ton frame. They are shorter on the side thickness of the rails and have different crossmembers. The one ton already has the rear leaf set up. I sent an email but I understand if it is to far away.

[Erl]

Yeah, Idaho is a long way from Texas. I will have to pass. Very interesting info on using a one ton frame. Have you done this or have any pictures?
Trevolet65, I am interested in the 351 and will let you know.

Erl

[BLK65K10]

I did all the measurements and it looked like it would work. I had a bent 4x4 frame and was going to swap everything over. but I have bought several 4x4 since and never got back to that project. I still have the stripped out oneton frame and the bent frame. I will see about taking some photos this weekend and email them to you.

[trevrolet65]

Originally Posted by Erl

Yeah, Idaho is a long way from Texas. I will have to pass. Very interesting info on using a one ton frame. Have you done this or have any pictures?
Trevolet65, I am interested in the 351 and will let you know.

Erl

The motor sold this weekend for $500. I'll keep a ear out if I hear of any more. Good luck on the frame.