The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > Engine and Drivetrain

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Old 01-29-2012, 12:37 AM   #1
pritch
Registered User
 
pritch's Avatar
 
Join Date: Mar 2004
Location: Hoytsville, Utah
Posts: 3,365
EZ positive-stop tool.

I've been needing a positive-stop tool, you know, to stop the #1 piston to find TDC. I thought about it for a while and came up with this. It took about 10 minutes to make, and it should work on every motor.

This is Uni-Strut. It is commonly used by plumbers and electricians at commercial construction sites. It comes in 10 or 20 foot sticks, but if you were to show up at a construction site and talk to any plumber or sparky, and maybe have a sack of donuts or something, they should hook you up. You only need a piece maybe 8" long. I used shallow strut, because it's all I had here at the time. Shallow strut is about 3/4 inch deep, but it comes in deep strut, too, and that's about 1 and a quarter inch deep. Either will work just the same. Notice the elongated holes in the strut, a 5/8" bolt will pass through easily:




I welded a 1/2" fine threaded nut to a flat washer, because it's easier to weld the nut to the washer and then weld the washer to the uni-strut:




Again, using what I had here. My head bolts are 1/2" , so I used these red-heads to take these pictures, I have since found some 1/2" X 4" carriage bolts. I use these because the threads go all the way up. At any rate, taking advantage of the elongated holes in the strut, bolt it to your block and there you go:



Simple yet effective.
__________________
'68 Panel
Project Boogie Chillin'
'68 C-10
Ol' Green
pritch is offline  
Old 01-30-2012, 06:41 PM   #2
ETsC10
Hand Crafted C-10
 
ETsC10's Avatar
 
Join Date: Aug 2006
Location: Burien, WA
Posts: 5,180
Re: EZ positive-stop tool.

Simple & effective Pritch!

PS--sent in for FAQ
ETsC10 is offline  
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:10 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com