Re: 76 2wd to 77 4wd Swap and Resto
Trav Rich-
This is a pretty straight forward swap. I did it, and the truck comes apart really easy. My build is in the 4x4 section. The only problem I had was the trans tunnel on the 2wd cab. It's about 3" shorter, and will hit the transfer case. Yours should have the bolt in tranny tunnel, so I'd cut out the 2wd tunnel, but leave a lip to bolt the 4wd tranny tunnel to. Otherwise, I lifted my bed off with an engine hoist with web straps in an "X" pattern accross the bed. I left my cab and front clip bolted together, and picked it up as one unit. I put jack stands under the core support, and jacked up the back of the cab a little bit at a time. Once it's high enough, you can roll out the 2wd frame and slide the 4wd one right under the truck and start letting it back down.
I didn't mention all the disconnecting. Brake lines, wiring harness at firewall, steering shaft, throtttle cable, e-brake....
Good luck though. It's pretty straight forward. Check out my thread for pics of the cab in the air. It's a lot easier if you have a lift....if not, this is the "poor boy" way.
__________________
1990 K5 Blazer (sold)
1983 SWB C-10 to K-20 Conversion
|