|
04-01-2013, 01:45 PM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: hillsdale mi
Posts: 46
|
driveshaft yoke
i got a th 400 with the bolt on yoke. can i unbolt that yoke and put a slip yoke in it? i got a one piece shaft now .
|
|
|
|
04-01-2013, 06:59 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: driveshaft yoke
Yes you can put a slip yoke in the transmission. Check the shaft first as there is probably a stop made on the shaft and a slip yoke can bottom out against it.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
04-01-2013, 08:31 PM
|
#3 |
|
Registered User
Join Date: Jun 2008
Location: Moss Point,Ms.
Posts: 1,439
|
Re: driveshaft yoke
To re-inforce what Jim posted,here is a thread I started on Chevy Talk not too long ago,asking the same question.
There is a very good link farther down in the post that's worth reading! http://www.chevytalk.org/fusionbb/sh...hp?tid/294600/ Mike.  /
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
