Wiring and horn problem on 66 c10

[Jmh2fb]

Thanks Ray. You were right. The steering shaft was up against the housing. Apparently there is a sleeve that goes around this although it didn't exist. I improvised with a garden hose. I cut a 4 inch long section and slid it over the shaft between the housing. Problem solved!

As for the lights a much trickier endeavor. I tried grounding wires but still no brake light on one side. Then I noticed that it lit when opposite blinker was on. With a buddy who is much smarter on these things and following your logic, we started at the low end of harness and traced back up to new turn lever. Inside the little switch interrupter the arms were not making contact correctly. We bent them with needle nose pliers and it's working!!!

Now if only I could find the lost key to the door. Spare works in ignition but not door. Small problem comparatively. Thanks again! J