LS Swap motor mounts.

[lynnfield]

Solidaxle, yes I had to have the drive shaft cut. The linkage I used from the donor truck (page 5 starting at post #119) I believe the stock linkage would have worked, but not 100% sure since I didn't go that route

Cdog73, If it were me, and you wanted to go that route, I would get a set of sbc engine stands and change them out for the 6cyl stands. They can be had on the parts board for around $25. I may even have a set laying around here you can have if you want them. Remember as solidaxle reminded me of, the drive shaft will need to be cut. As stated earlier the DD mounts do allow you to put everything anywhere you want, so that is also an option if you don't want to mess with the drive shaft.