The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 02-19-2015, 01:24 PM   #1
Fitz
Account Suspended
 
Join Date: Jan 2007
Location: Tucson
Posts: 2,183
Re: Drop question? 1 inch down on left compared to the right ?

Quote:
Originally Posted by jbassC10 View Post
My left front side drop is about 1 inch roughly lower than the front right side.

I've measured this at different locations to make sure it was just a hair higher elevation in the parkin lot then or over there etc. ~Tyler
You might not have a problem. When I built my truck I dropped it 4 1/2 inches in front and 5 in the rear with ECE drop coils and spindles. The first set of pictures is front and rear when assembly was finished. The 'experts' here claimed I could not have used the parts I said I did because the gaps between fender arch and wheels were HUGE. The second pics are taken after 200 miles on the truck after the suspension settled in. Compare the gaps. I believe your suspension is in the same state. Drive it a bit and check it again. I don't think you have "chevy lean" with new springs. I think it just needs to settle some.
Attached Images
    
Fitz is offline   Reply With Quote
Reply

Bookmarks

Tags
drop


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:48 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com