|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-10-2015, 06:35 PM
|
#1 |
|
Registered User
 Join Date: Dec 2014
Location: Kingston, TN
Posts: 67
|
Little help on CPP Cross member
Ok I need to make some temp. Bushings for my Nascar trailing arms so I can get my leaf spring rearend set up before sending the frame out to powder coat. What I need is the inside measurement on the trailing arm brackets on a CPP Cross member. Mine is on order and not sure when it will get here. Thanks for any help.
|
|
|
|
03-10-2015, 06:46 PM
|
#2 |
|
Quit if it's not FUN!!!
Join Date: Jul 2010
Location: Indian Trail, N.C,
Posts: 864
|
Re: Little help on CPP Cross member
Just call CPP. They should be able to help.
__________________
MY MOTTO: Eat it all up, Wear it out, Use the last few drops, Spend all you've got, Late in life, you'll think of the things you didn't do, not the things you did. - Get out and experience life ! . Robbie Robinson a.k.a. TobyArnot (Toe Bee or not toe bee) 
|
|
|
|
|
03-10-2015, 06:50 PM
|
#3 |
|
Registered User
Join Date: Dec 2014
Location: Kingston, TN
Posts: 67
|
Re: Little help on CPP Cross member
I tried to get them to tell me the U-Bolt center to center on their swap kit and they could only tell me it was for a 3" tube
|
|
|
|
|
03-10-2015, 08:57 PM
|
#4 |
|
Registered User
Join Date: Dec 2014
Location: Kingston, TN
Posts: 67
|
Re: Little help on CPP Cross member
Ttt
|
|
|
|
|
03-11-2015, 07:48 AM
|
#5 |
|
Registered User
Join Date: Dec 2014
Location: Kingston, TN
Posts: 67
|
Re: Little help on CPP Cross member
Ttt
|
|
|
|
|
03-11-2015, 07:50 PM
|
#6 |
|
Senior Member
Join Date: Oct 2014
Location: New Palestine In
Posts: 931
|
Re: Little help on CPP Cross member
Don't know about the CPP crossmember but the stock trailing arm bracket measurement is 2 3/4" inside. The rear u bolts are 4 1/4" center to center.U Bolts are 3/4" as are the traling arm bushing bolts. Hope this helps.
|
|
|
|
|
03-12-2015, 07:28 AM
|
#7 |
|
Registered User
Join Date: Dec 2014
Location: Kingston, TN
Posts: 67
|
Re: Little help on CPP Cross member
Thanks Rudy, That is exactly what I needed. You guys on this forum are awesome !
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
