Need some help 62 k10 d44

[JPBrecheisen]

Originally Posted by YOUNGBLOOD13

Working on a 62 K10 with D44, closed knuckle. I need two spindles, as these obviously went dry at some time and the bearings have cut into the step in the spindle. I found them at Quad 4x4, but at $400 per side, after adding bearings, seals, lube, and labor, a swap seems more logical. Anyone have spindles? If I want to swap complete axle, is there a bolt-in? Thanks for any help, I got a headache from searching the net

Try Border Parts 619-461-0171 for the spindles. I think I remember them having some. This spindle was used from 60-68. You might try salvage yards also.

You're looking for 22137x spindles on a dana 44 closed knuckle.

King pin bearings are 11590/11520. Can be ordered from any auto parts store.

Get your seals and king pin shims from Walcks 4wd. www.Walcks4wd.com Same stuff Quad 4x4 sells but at a much better price, and the seals are exactly the same.

Hope that helps. The closed knuckle stuff is out there, you just have to look unless you desire a swap. I wanted my original, so I looked around until I dug up what I needed.

Jonathon