Air ride and laying frame

[PBFAB.COM]

Originally Posted by Rednwhitec20

Can I just use c10 arms upper and lower then?
Posted via Mobile Device

Yes... lowers must be a 73-87 C10. Uppers can be from 63-87.

My understanding was that you wanted to keep it 8 lug up front. If that's the case, it will be a little more involved.

Nate

[Rednwhitec20]

Originally Posted by PBFAB.COM

Yes... lowers must be a 73-87 C10. Uppers can be from 63-87.

My understanding was that you wanted to keep it 8 lug up front. If that's the case, it will be a little more involved.

Nate

Which would be cheaper? Can I run c10 arms and keep it 8lug?
Posted via Mobile Device

[PBFAB.COM]

Originally Posted by Rednwhitec20

Which would be cheaper? Can I run c10 arms and keep it 8lug?
Posted via Mobile Device

The lower C10 and C20/C30 arms are dimensioned differently where the ball joint presses in.

There really isn't a cheap way to make the C10 lower work with a C20 spindle/ball joint combo.


Nate