![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
![]() Join Date: Jul 2014
Location: Dayton, TX
Posts: 335
|
WTB factory hard line for rear 4L80 fitting
I am needing a section of the factory hard line for the trans cooler line that fits the rear (deeper) fitting on a 05 4L80. I just need the part that clips into the fitting with a long enough end to get a compression fitting on. Shipping to 77535. Thanks.
__________________
'83 Silverado Step Side '85 GMC short bed. '86 Chevy Step Side Custom Deluxe LQ9/4L80 swap (SOLD) |
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Jul 2009
Location: Athens, AL
Posts: 499
|
Re: WTB factory hard line for rear 4L80 fitting
I have the tool to create the flare on a piece of steel tubing. How long of a piece of tubing do you need? Do you need the line for just one fitting or both?
|
![]() |
![]() |
![]() |
#3 |
Registered User
![]() Join Date: Jul 2014
Location: Dayton, TX
Posts: 335
|
Re: WTB factory hard line for rear 4L80 fitting
Thanks. I found what I was needing.
__________________
'83 Silverado Step Side '85 GMC short bed. '86 Chevy Step Side Custom Deluxe LQ9/4L80 swap (SOLD) |
![]() |
![]() |
![]() |
Bookmarks |
|
|