Brake Line Plumbing help..

[datguy]

So Master Cylinder and Booster came in today, along with the 3/16 hard line and pressure valves i'll be running. now i just need the fittings to order.. can any one point out the fittings i need to put it all together? where the brake guys at?


This here is the master cylinder and booster im running..

http://www.ebay.com/itm/67-72-Chevy-...ZU57gq&vxp=mtr

[ray_mcavoy]

According to the ebay listing in your link

Master cylinder outlets are 1/2-20 UNF and come with adapter fitting for 3/8-24 and 9/16-20.

So it looks like you have a couple choices.

(1) The cleanest looking would be to purchase some 1/2-20 brake line nuts that have a 3/16" center hole. Put those nuts on the ends of your 3/16" hard lines, double flare the ends, and screw them directly into the master cylinder.

(2) If you are using pre-flared sections of 3/16" hard line, they'll most likely have 3/8-24 nuts pre-installed. In that case, you could use the 3/8-24 adapter fittings that are supplied with the master cylinder.