|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-25-2016, 04:18 PM
|
#1 |
|
Registered User
Join Date: May 2016
Location: Mountain Home, Idaho
Posts: 1
|
1974 C10 New Belt Size?
I took off the AIR pump on my 1974 C10 w/350. I need to get a new belt and was wondering if anyone out there knows the new size needed or how to properly measure it out. Sorry I'm new at this haha.
|
|
|
|
05-25-2016, 07:01 PM
|
#2 |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,568
|
Re: 1974 C10 New Belt Size?
A good way to get in the ballpark is a piece of rope. Then buy that size along with one size longer and one size shorter.
For example, if the rope length is 45", pick up a 445, 450, and 455. And if you're lucky, one of them will work. If not, at least you'll be close to zeroing in on the correct size.
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! |
|
|
|
|
| Bookmarks |
| Tags |
| 1974 c10, belt, engine |
|
|
Linear Mode
