Raised bed. Did I do this right? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Richya · 06-21-2016, 06:19 PM

Hello all I am new to the forum,

I'm raising my bed floor and was wondering if someone out there can tell me if I'm doing this right before I get any further into it. What I did was measure from the top of the frame rail up to the top of the c-notch and cut that out of the sides of the bed side. I've looked around on the forum and found no pics or tutorial on a bolt together 73-87 bed.

Thanks Richy

SCOTI · 06-21-2016, 06:53 PM

There isn't only one way to attack this. There are several 'right' ways....
That method works.

06-21-2016, 06:19 PM	#1
Richya Registered User Join Date: Jun 2016 Location: Las vegas Posts: 12	Raised bed. Did I do this right? Hello all I am new to the forum, I'm raising my bed floor and was wondering if someone out there can tell me if I'm doing this right before I get any further into it. What I did was measure from the top of the frame rail up to the top of the c-notch and cut that out of the sides of the bed side. I've looked around on the forum and found no pics or tutorial on a bolt together 73-87 bed. Thanks Richy Attached Images

06-21-2016, 06:53 PM	#2
SCOTI Registered User Join Date: Apr 2001 Location: DALLAS,TX Posts: 21,954	Re: Raised bed. Did I do this right? There isn't only one way to attack this. There are several 'right' ways.... That method works. __________________ 67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... *Cubic inches is like Indiana Jones with a cheap pistol.*



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.