|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-20-2016, 12:04 PM
|
#1 |
|
Registered User
 Join Date: Jul 2016
Location: Texas
Posts: 19
|
SM465 transmission crossmember
Can someone confirm whether or not the late 60s and early 70s SM465 with a cast iron bell housing used a trans mount? I was thinking that set up used mounts on the bell housing and the SM465 bolted to the back of the bell housing without a rear mount. Thanks, RM
|
|
|
|
07-20-2016, 02:32 PM
|
#2 |
|
Restoring it $200 at a time...
Join Date: Aug 2008
Location: NE Kansas
Posts: 886
|
Re: SM465 transmission crossmember
The crossmember runs under the front of the SM465.
__________________
Charter member of the 'Put the dimmer switch back on the damn floor where it belongs' Society '68 5.3L-4 speed LWB C20; grandpa bought it for the farm in '71. Now LS 5.3, rather than 327. DD '09 Pilot Weekender '65 Skylark 300-4V-4 speed Wife's '07 Lexus ES350; 117 actuator motors and I can't see the engine. Son's '04 F250 SuperCab 6.0 |
|
|
|
|
07-20-2016, 05:31 PM
|
#3 |
|
Registered User
Join Date: Jul 2016
Location: Texas
Posts: 19
|
Re: SM465 transmission crossmember
Just to make sure I understand correctly, the transmission doesn't use a mount. It is bolted to and supported solely by the bell housing. Correct?
|
|
|
|
|
07-20-2016, 05:54 PM
|
#4 |
|
Registered User
Join Date: Nov 2014
Location: Southwest Kansas
Posts: 306
|
Re: SM465 transmission crossmember
Correct
|
|
|
|
|
07-20-2016, 08:38 PM
|
#5 |
|
Registered User
Join Date: Jul 2016
Location: Texas
Posts: 19
|
Re: SM465 transmission crossmember
Thanks! I am working on a 62 4wd and the truck has been highly modified. I am installing a 350 and an SM465. It has a divorced Rockwell T221N transfer case. http://67-72chevytrucks.com/vboard/a...1&d=1469061398
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
